• Matek System HUBOSD8-SE w/STOSD8-SE & 6S Max.
  • Matek System HUBOSD8-SE w/STOSD8-SE & 6S Max.
  • Matek System HUBOSD8-SE w/STOSD8-SE & 6S Max.
  • Matek System HUBOSD8-SE w/STOSD8-SE & 6S Max.
1/1

Matek System HUBOSD8-SE w/STOSD8-SE & 6S Max.

No. HP024-0003
SKU:
Login or Register to see prices
Received successfully
Coupon Code
CONTINUE SHOPPING
  • Matek System HUBOSD8-SE w/STOSD8-SE & 6S Max.
  • Matek System HUBOSD8-SE w/STOSD8-SE & 6S Max.
  • Description
General
Input voltage range: 9 - 27VDC(3~6s LiPo) w/ TVS protection
PDB: 4x30A (Max.4x46A)
Regulated 5V(POSCAP filtered) and 10V(MLCC filtered) outputs
Current Sensor 184A
Built-in STOSD8-SE

Physical:
- 2oz copper, 4-layers & 2mm PCB.
- 1x Battery input, 4x ESC outputs. 2x BEC 5V outputs, 2x BEC 10V outputs.
- Camera signal & Gnd pads, Video Transmitter Signal & Gnd pads
- 1x Serial port (RX, TX, G)
- RSSI input pad & Current sensor output pad
- Dimensions: 46x36x4mm, Weight: 9g
- Mounting holes 30.5mm square spacing,Φ3mm

PDB
Continuous current: 30A per output
Peak current (5 seconds/minute): 46A per output
Designed for RC Receivers, Flight controllers, OSD, and Servos.

BEC
Voltage: 5.0 +/- 0.1VDC
Continuous current: 1.5 Amps (Max.2A 10s/minute)
Output Ripple: 23mV (VIn=24V, [email protected] load)
Short-circuit tolerant (2 seconds/minute)
Designed for Video TX or FPV camera.
Voltage: 10.0 +/- 0.2VDC
Continuous current: 1.5 Amps (Max.2A 10s/minute)
Output Ripple: 15mV (VIn=24V, [email protected] load)
Short-circuit tolerant (2 seconds/minute)
10V can be used to power cameras labeled as 12V
The 3S LiPo input voltage should be 10.8V plus

Current Sensor
184A Max.
Current signal output: 3.3V ADC for Flight controler
Tips: If current signal pad is connected to FC, The CURRENT METER must be ON in FC GUI.
Scale the output voltage to milliamps(1/10th mV/A): 179
Frequently Bought Together
more
Frequently Bought Together